Novus Error Codes – Decoded!
| Error Code | Description |
| 11 | Eeprom checksum-problem. In case it repeats, change main CB assy |
| 12 | Motor home positioning error (stuck module, failure in Opto CB assy or broken main CB assy) |
| 13 | Software bug |
| 14 | Pipette overheated |
| 15 | Battery low or battery empty or battery disconnected (SW version 4.0) |
| 16 | Dispensing cycle is interrupted or Battery disconnected (SW version 4.1) |
Replacement Parts:
Finnpipette Novus Single Channel Parts
Finnpipette Novus Multichannel Parts
Related Posts:
Finnpipette F1 and F2 Tip Ejector Mechanism Replacement
Finnpipette Digital (Model 4500) Single Channel: How to Service and Replace the Tip Ejector Assembly
The Reality of Electronic Pipette Calibration
Electronic Pipette Error Message
Disclaimer: Any action you take using the information on this website is strictly at your own risk. The information herein does not constitute professional advice and is general in nature. We make no warranty that this information will meet your requirements, be safe, accurate, or error-free. Pipette Supplies, Inc. is not responsible for any errors or omissions, any results obtained from the use of this information, or any loss or damage arising out of the use of this information. This site is for educational purposes only.
Fair Use: Copyright Disclaimer under section 107 of the Copyright Act of 1976, allows for “fair use” for purposes such as comments, criticism, teaching, scholarship, news reporting, and research.
Fair use is permitted by copyright statute that might otherwise be infringing.
Hello
My FinnPipette 1-10 uL is reading Error Code 12 and then Remove Module. Are these errors that I can fix, or do I need to send the pipette in for repair?
Thank you
Hi Alisha,
We recommend sending your pipette in for service. If you would like us to recommend a service provider, please contact us via phone (817-483-9883) or via the Contact Us page.